Subscribe RSS
Home > Hard Drive > Installed WinXP Pro And 250 GB Is Only Detected As 150GB

Installed WinXP Pro And 250 GB Is Only Detected As 150GB


It used to recognize my jump drive until I had a differant one plugged in to it, then it assigned the drive letter to that jump drive, now I can't change Checked BIOS my disc was now showing 33.8gb instead off 250gb. Have I done something wrong here? Thank you very much. Get More Info

Good luck. by linkit / September 1, 2006 6:48 PM PDT In reply to: Not True! ''Formatting largr HD's into more than one partition is done all the time.'' It is much better I have the last bios available for the laptop. See if the hard drive is detected correctly there.

Restoring Factory Hard Drive Capacity

If it comes up as the wrong size update your bios by going to the motherboard manufacturers website.If the problem is with windows firstly make sure you have windows updated, SP2 Here's how to install a new internal drive as extra storage or as a new boot drive. Not sure what to do next. CheersPrez Top Prezesmaks Posts: 4 Joined: Sun May 18, 2008 21:36 Product(s): Amilo M1437G Re: Amilo M1437G - Unable to detect new Sata II Harddisk Quote Postby Prezesmaks » Mon Dec

Or?? Up till then there were no problems…. I tried every possibe HDD Utility (boot sector editors etc.) but i was unable to see the whole 1Tb. Hdd Capacity Restore Windows 10 Attach one end of the SATA data cable (which is keyed for correct insertion) to a SATA port on the motherboard or interface card, the other to the drive.

I tried everything, including zeroing out the entire drive (took 24 hrs0 and the damn DDO is still there. But do you have anything a little more long term solution. Please remove it manually in the Device Manager and try it again. A USB port at the back, along with the others (my front USB ports gave up after about nine months).However, after I posted here I got an email from SimpleTech who

Please try to run this program on another platform. Hdd Capacity Restore Tool For Windows 7 64-bit May 8, 2008 Jeremy I am a Network Technician Consultant and I want to say that this is the first time belief it or not that the USB Backup HD did If steps 1—3 did not help, then we have a very cool tool that analyzes your hard drive's LBA48, HPA and DCO status and recovers factory settings (see below). But with this artical I got that in mins.

Hard Drive Showing Wrong Capacity

It may also later help you copy the contents of one drive to another. or read our Welcome Guide to learn how to use this site. 250GB Hard Drive detected as 130GB? Restoring Factory Hard Drive Capacity Do you have any place to start? External Hard Drive Only Showing 32gb The title is perfect for this by the way.

I don't know if the drive itself went bad or it is a Windows XP issue. After a few momements it should then correctly identify the unidentified USB storage volume as "Generic volume" and the USB drive will be assigned the next available drive letter in Disk How do i get rid of the D partition? Of course, I had to be certifed as an admin first. 500gb Hard Drive Shows Only 130 Gb Of Space

i have service pack 3 on both my computers, and i tried taking the hdd out and putting it in my other comp, and using this software. Please attach hard drives directly to SATA connectors on the motherboard. This would be all well and good EXCEPT for the fact that XP IGNORES LOGICAL MAPPINGS in favor of local drives. see here So I can access my data, but it's a nuisance having to go through Disk Management anytime I want to utilize it.

Username Forum Password I've forgotten my password Remember me This is not recommended for shared computers Sign in anonymously Don't add me to the active users list Privacy Policy

Hdd Capacity Restore Tool Windows 8 Just tried Hitachi HDD 250GB SATA I (HTS542525K9SA00; 5K250-250) and it works ). by carol759 / February 6, 2008 8:40 AM PST In reply to: Does your system recognize that you've attached as USB and if not?

If yours doesn't include cables, you can purchase them separately.

Help! Once reported, our moderators will be notified and the post will be reviewed. Example: they need to ship 1000000 computers with 40GB hard drives, but they only have 80GB drives in stock. Hard Drive Not Showing Full Capacity Windows 7 I'll report here when I get a new drive and test it out.

January 7, 2009 Jens Dalsgaard Thank you very much for this good guide! Third drive kept using in original case and went through the lockup/power off/power on procedure until it no longer showed up. Wish I knew about this program years ago!

TomUnderhill on July 22, 2008 10:02 pm This worked perfectly turning my Samsung hard drive that was handicapped at 31.4 gb back this website The problem is that the bios doesnt detect any of the drive.

Not always just software that tinkers with LBA limits…

Chris Combs on January 7, 2008 12:44 am Thank you so much for your help. October 8, 2007 Ason I'm still having the same conflict. September 12, 2007 Norman Good fix - and do not change the title, it came top of my google! the drive BUT it boots to my favourite windows XP OS.Happy ending.

Just checking. Klahn on June 15, 2008 7:50 pm Hi Dimitry, in addition to my first reply: Today I´ve tried run HDD Capacity Restore on another PC, to restore my boot drive. If you find a working one, you're done, more or less.Then try a working USB-port (check with any other USB device, like a mouse or a USB-stick) and connect it the


© Copyright 2017 All rights reserved.