Subscribe RSS
Home > Hard Drive > HD Capacity Problem

HD Capacity Problem


That means, completely power off your computer; then power on, start Windows and run the tool. The device has to be single on a channel" I am on XP trying to fix a samsung 160gb drive showing on your program as Master IDE controller Channel#0,slave 33gb. But Hard Disk Drive (HDD) capacity has more to do with physics. So, I decided to apply a firmware update (found from Compaq, SP16768) in case I got read of the strange clicks and clacks. my response

It is recommended to check and modify the configuration or upgrade the operating system, hard disk controller and/or drivers to safely use this device. Compatibility problem overview Older hardware and/or Oturum aç 6 Yükleniyor... Note on my end, I had to use Disk Management to first remove the 31.4 gig partition, so it's completely unallocated. Thing is that my OS is on this drive, and using your tool it says I must disconnect this from computer.

Hard Drive Capacity Restore

Telephone line rental, Broadband connection etc. the problem was solved, even in the bios!!! I'm 24. It is a 250 GB drive, but it only showed 60GB +/-.

or is too late ?????? have i got a bigger problem here? Carefully identify the one you want; you are actually pretty safe since I think that you will only your primary drive, the one you want to format, and a CD drive. Hdd Capacity Restore Windows 10 Third drive kept using in original case and went through the lockup/power off/power on procedure until it no longer showed up.

Can I use your program to restore hard drive capacity from primary hard disk? Hard Drive Not Showing Full Capacity It did read 60 gigs at first before I cloned my other 40 gig drive to the 60 gig drive. Pay attention about such capacity-related warnings especially if you prefer to use an older USB adapter/enclosure/docking station with a newly purchased high capacity hard disk drive Verify the situation especially if t3o PC Gaming Support 1 03-24-2012 07:38 AM dsl 2680 problem Hi there, 1st time poster here, I have a problem with a talk talk dsl 2680modem or the connection?

With disk manager he says c/ (c:) partition basic ntfs healthy(system) 128,00GB 94.89GB But underneath it says disk1 c/ (c:) 298.09GB ntfs healty(system). Why Does My Hard Drive Not Show Full Capacity The solution is to either fix the displayed size to match the unit or fix the unit to match the display size. However, if the declared and the actual sizes differ by more than the difference related to the "binary"/"decimal" unit, most likely, you are dealing with a phenomenon called "capacity clipping". Thank you so much for freely distributing this siftware.

Hard Drive Not Showing Full Capacity

picstrubikJan 10, 2011, 3:09 AM beamj said: Start from your Mac OS X Install disc; use Disk UtilityInsert your Mac OS X 10.4 or 10.5 installation disc (if you have discs click here now September 5, 2012 Wayne Riker Good article. Hard Drive Capacity Restore I don't want to format the disk now, just continue to use it as a backup disk just in case of failure of my SSD one. Hard Drive Showing Wrong Capacity Lütfen daha sonra yeniden deneyin. 25 Haz 2012 tarihinde yayınlandıSeagate Barracuda 7200.10 LBA=0 How to repair this error?

So it is a number-trick (like the author wrote, a marketing trick) to sell you smaller disks for same price. dig this Within 1 minute everything was back to normal. Would like to see a follow article up for ADS (Alternate Data Stream) metafile on NTFS partions. Thanks….. Hard Drive Not Showing Full Capacity Windows 7

By 512 bytes/sector, it is 2199023255040 bytes, slightly more than 2 TB (2199023255040 / 1024 / 1024 / 1024). It says so right on the box !! ;-) September 3, 2012 clamo @Siosilvar: please get a real education. After a computer crash both of them became 137GB (in bios and xp). pop over to these guys As we can see in the screenshot below, nearly 11 GB of the hard drive’s space is reserved for a hidden recovery partition.

Dilinizi seçin. 500gb Hard Drive Shows Only 130 Gb Of Space To do so, you need to visit the motherboard vendor web site. But that's not possible since this is my main drive.

Not sure how could that happen though…

Dmitry Postrigan on May 7, 2008 7:46 pm Eugene I am sorry, but I do not think this is possible at this time

The firmware was indeed for MPG3102AT-E and the firmware was updated to ver.9211. I'm so dumb that I thought the remaining space was preserved for over provisioning. Any chance on making the app more portable? Hdd Capacity Restore Tool For Windows 7 64-bit Thanks.

jon jost on September 23, 2007 6:46 am Hello Jon, You would have to attach this hard drive to a computer that already has a hard drive to boot

But it is possible to verify the situation this way: After right click on Computer, select Manage -> Disk Management option and then select the appropriate hard disk, it is possible it says the hdd is already at factory 250 capacity, and after i ran the software the drive dissapared from ‘my computer'. You can put it on an FAT thumbdrive as the ADS will be stripped during the move. my site You’ll need to run it as Administrator – to open a Command Prompt window as Administrator, search for Command Prompt in the Start menu, right-click the Command Prompt shortcut, and select

From online forums, apparently problem with the case. In any case, thanks a lot for your help. Please help!!

Ken on July 12, 2008 12:34 am Ken: Please try CTRL+F while on this page and then type "USB"; and you will find your answer :)

Dmitry My previously useless hard drive [mysteriously reporting to windows as 33GB unformatted instead of 160GB 80% full of stuff] has been resuscitated in two clicks by this program.

So does anybody knows a way to restore the capacity of that HDD again back to 200 GB? Is there chance to recover my files or HDD? The hard drive should report its correct size in the Disk Management window. Sometimes a very broken hard drive may report wrong capacity.

Your e-mail address is kept securely (see our privacy policy). © 2016 H.D.S. Please suggest….. why was is shipped from Samsung like this?

Tom Walter on July 15, 2008 8:53 pm Encountered odd problem and tool didn't even recognize drive. Several days ago it started crashing the machine and dissappearing from the BIOS, only to be detected again after disconnecting and reconnecting the drive (I thought it was caused by bad

My first personal HDD was a 10MB that cost $995 in 1980!!


© Copyright 2017 All rights reserved.