hosting3.net

Subscribe RSS
 
Home > Hard Drive > Different Sata Drives In Asus P4p800

Different Sata Drives In Asus P4p800

Contents

So there could be something going on, and I'll think about it some more, but if all the settings and cabling check out, I'm inclined to think you may just be Unfortunately, I do not have a floppy drive or cd burner around. ATI x800 graphics card. 3 x SATA hard drives, L7 in C: partition. View Related Posts . . http://hosting3.net/hard-drive/sata-ide-hard-drives-no-sata-drive-in-my-computer.html

There are two things to keep in mind, do not overload your power supply or strange difficult problems will begin to occur and make the correct BIOS settings for your data You may also... Posted On: 05-08-2009, 05:42 PM . you rock!

How To Connect Ide Hard Drive To Sata Motherboard

Look for the DRIVERS directory. i am in the vail colorado valley and its feast or famen up here. *as far as the raid post goes KEEP THE DISK IN THE FLOPPY DRIVE! I am using them in "IDE"mode, that is, the settings are done in BIOS and no drivers are required, the only time drivers are required are when using raid or, on

By the way, what are the short pci express slots for? Flag Permalink This was helpful (1) Collapse - It's all about the controllers by DJPython / July 22, 2005 5:53 AM PDT In reply to: Mixing SATA and IDE drives in View Related Posts . . How To Make Ide Boot Instead Of Sata Because the sustained rates were the same, I probably wouldn't get better performance from SATA-II for my use but that doesn't mean in another use the performance wouldn't be much better.Anyway,

This will allow you to use your RAID. Sata And Ide Hard Drives Together If you enter bios setup again and exit with no changes it boots to the sata 0 hd and life is good. I shoulda Googled before posting here. http://www.chovy.com/ui-design/install-sata-hdd-on-asus-a8v-deluxe-motherboard/ Checked it anyways but it was good.

It's better to have SATA for primary, but the speed wouldn't be a big difference Flag Permalink This was helpful (0) Collapse - I have a problem with mine by Laurenksmith Ide Hard Drive Jumper Settings SHOW ME NOW CNET © CBS Interactive Inc.  /  All Rights Reserved. No idea what to do. I need some recommendations on a... » Site Navigation » Forum> User CP> FAQ> Support.Me> Steam Error 118> 10.0.0.2> Trusteer Endpoint Protection All times are GMT -7.

Sata And Ide Hard Drives Together

Sys. 1: Sony VAIO VPCF13UFX/B, Intel Core i7-740QM (1.73GHz), 4GB RAM, Windows 7 Home Premium (64-bit), Nvidia Geforce 310M, MC 8.7 Sys. 2: Acer Aspire... [view my complete system specs] Scott Asus X58 Sabertooth motherboard, Core i7 920 CPU, Win 7 Pro 64bit, NVIDIA GeForce GT610, 12GB Corsair 3x4GB CMX-12GX3M3A1333C9 ram in triple channel config... [view my complete system specs] Page 1 How To Connect Ide Hard Drive To Sata Motherboard I don't know your motherboard, but check the connectors on it in your manual, and what settings you may have to set to use it as "IDE". Ide And Sata Drives In Same Computer I unplugged both and plugged the hard drives into ide2, and whaddya know, it worked.

http://www.anandtech.com/storage/showdoc.aspx?i=2628 As you can see, if you read the full test,some of theSATA drives are only 1.5 GB/s but in these tests the WD4000YR, which is a 1.5 GB/s rated drive,outperformed More about the author The sustained speed is what I gave you but I called it continuous. Larry as long as I live I will remember you. 3 Heads Digital Media Fri, Jun 30 2006 10:43 AM In reply to Ian McMahon Joined on Wed, Nov 23 I haven't tried putting the slave dvd as a master yet but i'll try that as the first thing when i get back. Motherboard With Ide And Sata Ports

Fri, Jun 30 2006 11:50 PM In reply to smyers63 Joined on Thu, Feb 16 2006 Dallas, Texas Posts 3,736 Points 44,065 Re: IDE and SATA Drives - ASUS P4P800 Reply Please enter setup to configure your system. I put in a new motherboard recently and couldn't figure out why I could no longer access my IDE HD. check my blog I've had a 200GB SATA running off my separate SATA controller for three months now.

Without it I would have taken a sledgehammer to my motherboard. What Are The Two Goals When Implementing A Raid Solution DDR2 and 3? You have to have the RAID software for intel chipsets if you are going to RAID 2 disks.

All submitted content is subject to our Terms of Use.

I suspect this advantage disapears if the head has to hunt all over the platter-the logic of frequent defragmentation factors in again. do you have it setup in the bios that way as well? Can i use both primary and secondary ide channels while using sata? How Many Hard Drives Can Be Connected To A Single Ide Cable View 11 Replies .

If i try to copy a large file from CDRW to SATA WD disk, the CPU goes to 50% and i'm not able to start or use any other multitasking application. Flag Permalink This was helpful (1) Collapse - It's about reading mobo doc and following instructions by Doug_Hirschfeld / July 28, 2005 11:10 AM PDT In reply to: It's all about Wd 80gb sata / port 1Wd 160gb ide / port 2 (I will eventually get a hold of another 80gb wd to raid them up. news Ide To Sata Converter So, i'm going to install as many drives as i can in my machine.

Winamp stops playing, until the copy is finished. My best advice is read your documentation if you don't understand it have your dealer help you and then do what it says, and really be certain to use an adequate All this apps from Intel are expecting to see ICH5R chip and they are not running. no raid at all.

However my current computer doesn't have any ide ports or molex power connectors. Posted On: April 7th 2005 . I now know how the SATA-I at 150MB/s can outperform by so much the PATA/IDE at 133MB/s. But now, a new problem.

Usb 2.0 To Sata Ide Cable Does Not Work I tried to use new branded "r-driver iii" usb 2. 0 to sata ide cable device with laptop hd and desktop hd Enhanced mode device support must be set on to use a mixed device configuration. How would i go about doing all of this?Anyone know any tutorials on how to connect a ide to a sata system? or am i stuck with SATA I and its 150Mbps transfer speeds?

can my motherboard handle SATA II hard disc's so i can take advantage of the 300Mbps tranfer speed?? I never do things right the first time. About CNET Privacy Policy Ad Choice Terms of Use Mobile User Agreement Help Center Get Help Fast Product Registration Customer Service Email Us Find service locations Hot Link MyASUS App ASUS However the perpendicular drives seem to gain an inherent advantage due to the increased density on the platter.

Went right in the first time. Posted On: 4 weeks ago . Choose between the defaults, which should be Performance (Stripe), Data Security (Mirror), Safety and Performance (Stripe and Mirror) or Capacity (Spanning). 3. The same problem is when i copy large file between 2 partitions on the same disk.

Standard hard drives are not nearly fast enough to stress the PATA or SATA-I interface never mind the SATA-II. Flag Permalink This was helpful (0) Collapse - also sata ide troubles by babs123456 / November 14, 2006 1:30 AM PST In reply to: mixing of sata and ide i too

 
 
 

© Copyright 2017 hosting3.net. All rights reserved.