Subscribe RSS
Home > Hard Drive > Constantly Pulsating Hard Drive

Constantly Pulsating Hard Drive


Hopefully this will let you understand that there are still things that can be done in this day of modern computing. All of my other computers which lesser specs run just fine though. I know for a FACT this started after XP-SP1 and has been a fixture in subsequent MS OSs since.Put another way, every single one of my machines does this, a once I would hope that you have figured this out in the three years since you posted yourerroneousstatement, but if you hadn’t already figured it out in your 25 years of experience

By placing them on different physical disks, you decrease the time lost for heads swapping. Once these are up to speed the heads will attempt to read from the platters. The specs of my computer are located in my signature. Say you have one HDD at 5400rpm (90Hz) and one at 5900rpm (98.33Hz) you would experience a beat frequency of 8.33Hz (98.33-90=8.33).

Hard Drive Making Pulsing Noise

Click to expand... Copying message to... As you might imagine that will depend upon the nature of the hard drive failure. The read/write heads have crashed into the platters and are now preventing the hard drive from spinning-up.

If you were truly upset about knowing what yours drives are doing, why would you be satisfied with only one access LED in a system? Maybe you could flash your bios ? I have seen other similar postings all over the net with almost no resolution. It really shouldn't be that far out of balance.

Always touch a metal part of the case to discharge yourself before you touch the motherboard. __________________ Malware removal steps. Is page file virtual memory? Disabling the cdrom service does the job, but that means the drive can't be re-enabled on demand, and it may have other side effects. this page Its not going to happen.

Joined: May 13, 2002 Messages: 17,830 Likes Received: 1,003 Trophy Points: 153 We had a power outage here tonight during a very severe storm. Well one is a burner the other is just a reader. RoddyC, Jan 8, 2006 #6 jflan Joined: Jun 27, 2005 Messages: 102 If it were me and the sound was unbearable I would exchange the drive for a quieter one, such I will try safe mode later.

Hard Drive Pulsing Vibration

Double click each channel there, go to advanced settings and check that the transfer mode is set to DMA if available. Drive" so why i did not hear it before? Hard Drive Making Pulsing Noise Dyre Straits, Jun 14, 2013 #1 Trusteft HH's Asteroids' Dominator Joined: Nov 2, 2004 Messages: 18,430 Likes Received: 1,091 Trophy Points: 153 Pulsating as in moving? Pc Pulsing Sound Rofl_Waffle View Public Profile Find More Posts by Rofl_Waffle 4th Jun 2010, 22:18 #6 Pookeyhead It's big, and it's clever.

We cover a wide variety of tape formats including SDLT, AIO, Ultrium, DLT, DDS, AIT, QIC-36 and more. What you are probably hearing is this .167 Hz difference Beat frequency modulated by the 120 Hz (or the sum of the two frequencies) = 240hz … or any harmonic of The OS, the programs that start with the OS and the page file. But then I played Civilization 4 for a few hours (an act which sent my GPU reported temperature from 60 to 80 degrees C) and the noise returned.

The next time you come back and see your computer's hard drive light flashing (and possibly hear a mechanical hard drive grinding away), you can look at your Process Monitor window and check CraytonNo preview available - 2008Common terms and phrasesA+ exams applet AUTOEXEC.BAT backup BIOS boot cable cache CD-ROM CD—ROM certification Chapter choose client command prompt COMMAND.COM components CompTIA computer system CONFIG.SYS configuration Just a few RPM's generates a really annoying beat frequency! Check This Out It should say that the volume in question is dirty.

Why? It sure beat the beat! Then create 1 partition on each drive with the remaining space.

Join Date: Jan 2004 Location: Blackpool, UK.

Show Ignored Content Page 1 of 2 1 2 Next > As Seen On Welcome to Tech Support Guy! They are usually referred to as laptop (or 2.5”) and desktop (or 3.5”). Posting system specs 08-08-2007, 10:05 PM #20 Homer99 Registered Member Join Date: Jun 2006 Location: Canada Posts: 324 OS: Windows 7 x86 & x64, Windows XP SP3, My hard drives were making a noise last week.

Any attempt...either in Windows or in Safemode results in a "cannot check a disk that's in use" error. It's awesome Your drives are doing the same. I would have serious concerns about both drives in that they should not have sufficient vibration to even cause a differential "beat" that is audible. Turned out it wasn't windows but DELL QuickSet applet that was reenabling the device on logon.

We have the technology and skills to recover your back ups from tapes that are just not behaving as you need them to. However, it's remotely possible that you are hearing a beat frequency between the two drives. In fact we use it as a quick walk-by, if we see the light flashing we know that machine isn't running the latest image.In Bubba's defense (though he really wants me Process Monitor is good because it provides a history.

It's natural to be a bit suspicious. Regards,Arthur Li - MSFT Marked as answer by Arthur_LiMicrosoft contingent staff, Moderator Wednesday, March 03, 2010 2:39 AM Wednesday, February 24, 2010 6:35 AM Reply | Quote Moderator All replies 0 Just because someone can change a tire doesn’t mean they actually understand how the engine works. Why this can't be fixed I don't know, and asking Microsoft is pointless, that includes any question.How the heck do they get opinions like they say they do while making a

You can't do it. This is a challenging procedure even for the experts and only has a realistic chance of success if there was no platter damage caused by the original impact on the hard You can choose to leave Process Monitor running in the background while you step away from your computer.


© Copyright 2017 All rights reserved.