Subscribe RSS
Home > Hard Drive > Can A Hard Drive Larger Than 127gb Be Used As The Boot Drive.

Can A Hard Drive Larger Than 127gb Be Used As The Boot Drive.


solved I just got a new case and motherboard for my pc, using my old hard drive, however its seems a ton slower than usual solved can you use toshiba recovery Magic cases These include things like HDD firmware bugs (believe me, there are plenty of them). Please refer to our CNET Forums policies for details. XP couldn't since it was 32 bit, but your 64 bit version can access it. you can try this out

After restarting OS I started the HDD Capacity Restore, choose the WD1200JB (Master on SEK IDE) and run the tool. Preview post Submit post Cancel post You are reporting the following post: Can Windows OS use hard drives larger than two terabytes? After I ran [email protected] Partition Recovery (part of [emailprotected] freeware bundle), it found out that ~50GB of hard disk space was unallocated. A few bucks is a bargain for this free utility.

Windows 10 Maximum Hard Drive Size

Removed the new drive and attached via USB to my pc running your Capacity Restore Freeware. Hi Terry,You have an 'E' drive and also an external half terrabyte drive that is full.Plus your system is running slow, and you want some advice on purchasing a single Buffalo Furthermore, partition the disk (that is divide it into smaller chunks that Windows will access as separate drives). Is there a chance that I did something wrong?

I have another mirrored set of drives to make sure I have my data if something happens. Normally you have a 2TB limit. When I start HDD Capacity Restore and choose my PRI MASTER IDE drive (that is a WD1200JB) to restore, it says me: "The drive you choosen is used and cannot be Windows 10 2tb Limit PLEASE if anyone can help I would be forever in debt.

Loaded XP home validated load Vista validated system running perfectly wonderful I thought until I REBOOTED when the system told me it could not load windows F… . Windows 7 Maximum Hard Drive Size Note on my end, I had to use Disk Management to first remove the 31.4 gig partition, so it's completely unallocated. Thank you. Found this software and bingo had my original drive back in seconds.


CDG on October 23, 2007 9:29 pm Can you elaborate on the affhdd.sys driver? 4tb Hard Drive Windows 7 The drive has nothing on it and has been installed on it's on channel. And the Hitachi tool didn't allow med to go above the factory default.

Roger on May 3, 2008 8:58 am Any chance releasing this tool on a self-boot iso image? Also i have tried this type of restoration before using ghost, and found the drive to become very unstable in saving data.

Windows 7 Maximum Hard Drive Size

My undying gratitude, Dmitry…If I were going to have kids, I'd name one after you…maybe two.

fluxtatic on December 5, 2007 10:05 am whit this tool can i fixed my Then when I clicked this warning poped up? … Device is in use and can't be removed. Windows 10 Maximum Hard Drive Size start up, automatic repair, &... Windows 10 4tb Hard Drive At the end of this article there is a link to our program that recovers factory capacity of any hard drive. "My hard drive has mysteriously became smaller!

If you don't like the stock appearance of Google Home, here are two quick and easy ways to make it truly yours. directory After the clone the disk showed as a 32Mb Drive. This seems to be a general failure of the program.

czer27 on June 18, 2008 6:46 pm czer27: It is possible that you have a file system or partition corruption Ask ! Maximum Hard Drive Size Windows 7 64 Bit

by wpgwpg / October 3, 2014 10:50 AM PDT In reply to: Can Windows OS use hard drives larger than two terabytes? Your explanation put my mind at rest. now, everything ran smoothly until i tried to install dvb-s card driver. I've found out that disk2vhd only supports files up to 127GB, so I'm about 73GB over this limit.

Any suggestions ? Gpt-mode It worked perfectly. The device has to be single on a channel" I am on XP trying to fix a samsung 160gb drive showing on your program as Master IDE controller Channel#0,slave 33gb.

I ran the HDD restore program and it says that "the drive is already at full capacity" (In which I know it's not) "no restoration is needed".

  1. It restored my 1Tb Disk instantly.
  2. No longer valid in Windows 7 and particularly Windows 8.
  3. Several days ago it started crashing the machine and dissappearing from the BIOS, only to be detected again after disconnecting and reconnecting the drive (I thought it was caused by bad
  4. thank you

    Billy on October 10, 2007 10:46 pm And something else too.
  5. Flag Permalink This was helpful (1) Collapse - Yes you can...if running Windows 7 64 bit by pauly1651 / October 10, 2014 11:44 AM PDT In reply to: Can Windows OS
  6. Thanks

    Dmitry Postrigan on January 28, 2008 7:20 pm I recently bought a new WD10EACS 1Tb WD Drive that i tried to clone with Acronis.
  7. The VHD file has jjust over 200GB and it doesn't work when I try to boot from it in hyper-v (missing operating system error).
  8. Trying to make this work in a WinPE environment without any luck.
  9. Help Desk » Inventory » Monitor » Community » CNET Reviews Best Products CNET 100 Appliances Audio Cameras Cars Desktops Drones Headphones Laptops Networking Phones Printers Smart Home Tablets TVs Virtual
  10. Of course I only have one HD controller.

USB mass storage is not going to be supported since it simply does not allow the protocol that we are using to access the hard drive. i've restarted my computer but it doesnt take any effect. O_O thank you so much :)

clint on May 7, 2008 5:06 am Roger: In this case I guess it might be damaged somehow. Windows 10 6tb Hard Drive Windows XP (without SP2) only recognises drives up to around 127 gig.

The hard drives have applications that I can't replace. Our expert industry analysis and practical solutions help you make better buying decisions and get more from technology.... MagMy libraryHelpAdvanced Book SearchTelliOstke raamatuid Google PlaystSirvige maailma suurimat raamatupoodi ja alustage juba The HDD Capacity Restore Tool can only restore the factory default but since that one is wrong it doesn't work for me.

Roger on May 2, 2008 9:25 am Roger: Please try to run this program on another platform”.

Thank you very much for both of your great tools that you share with the world.

JasFromColo on January 7, 2008 6:34 am I connected my device on a single if i reboot it shows up again but still at 127gig.

kevin on July 2, 2008 7:40 am Solved my problem with SATA drive with an adapter from Addonics in I downloaded this tool and I am getting a message when I click on the desired hard drive, that there are two devices on a single channel. SySaAzm

SySaAzm on March 18, 2008 9:01 am HDDGURU is my HERO!


© Copyright 2017 All rights reserved.