hosting3.net

Subscribe RSS
 
Home > Black Screen > Black Screen With Blinking Cursor & M1004 Error Code: Dell Inspiron 6000 With XP Pro

Black Screen With Blinking Cursor & M1004 Error Code: Dell Inspiron 6000 With XP Pro

I get the microsoft screen with the hourglass telling me to wait but, after about 15 minutes i get a totally black screen with a cursor at the top right hand It loads up but it goes to a screen where it says: No boot sector on internal hard drive. Am getting no lights at all but the AC adaptor is fine. Thank you! Read More Here

Diagnosis: Cracked solder joint on positive or ground connection of DC Power Jack. I don't know. Connect the external screen to the VGA port on the back and start the laptop. I have tried 0, 1, and 2. http://www.techsupportforum.com/forums/f10/black-screen-with-blinking-cursor-and-m1004-error-code-dell-inspiron-6000-with-xp-pro-401756.html

Does your laptop makes any kind of sounds when you push on the power button? In your case I would send it back to them and ask to fix the problem. Now, I unplug the video cable from the motherboard and reinsert it into the outlet; press the Power Button and the system starts-up with video.

it look booting in few momment and then hang again. Checked all connections as far as humanly possible. I've tried all of the possible solutions I found on the internet forums. Steve December 4, 2007 | I have a Compaq Presario V5000 with the exact same problem that Benny describes in Post 58.

I'm trying to figure out what to do now, as I unfortunately didn't back up about 1 GB of pictures that I need to get off this hard drive. When I press the power button, the power light shows up, but as soon as I release the button, the light dissapears and the laptop doesnt start (nothing on the screen). when i turn it on, it shows the HP Splash and goes to the Windows Xp loading screen for about 2 seconds, then it bluescreens and restarts. http://newwikipost.org/topic/SeyLuLSVosLhXPP4HfRtWCu8fpXuwkEY/Inspiron-6000-blue-screen-can-t-read-hd.html In this case you'll have to replace the motherboard or use the laptop just on AC power.

In both cases, it's necessary to open up the laptop and take a closer look at the motherboard. Disconnect the LCD screen from the motherboard (connector is located under the keyboard) and test the laptop again. 4. Man, I wouldn't touch a Toshiba Satellite Pro 6100 with a 10-foot pole. I have checked the voltage from adapter and it's correct.

  1. Any LED activity?
  2. This morning I received an error code M1004 (something about overheating) and the computer was frozen at that point.
  3. Here's how you can test it.
  4. Is there a chance this message to refer to the RTS battery?
  5. Your cache administrator is webmaster.
  6. Tried another adaptor but still no response.
  7. PSM70E-00U00FDU,Having a problem with charging,power adaptor tested ok with correctly voltage open up circuit fuse tested o.k help….what could be a problem Regards Wilson Sami June 27, 2007 | I have

I cleaned out dust from the heat deck, as it was completely blocked with dust. Try reseating the memory modules. Also this problem might appear because of a faulty memory module, try some tips from the situation 2. Try reseating the memory module, just remove it from the slot on the motherboard and install it back.

You restart the laptop but the same problem appears again Most likely it's a heat related issue. hop over to this website Join the community here, it only takes a minute. Other than these, the laptop was in working condition. Thanks!

Thks in advance for assisting. Honestly, I'm not entirely sure what the problem is. cj2600 January 5, 2008 | Fernando, What if you remove the hard drive and try turning it on without the hard drive installed. http://hosting3.net/black-screen/dell-inspiron-n5030-black-screen-and-flashing-cursor-at-start.html Thank you.

Select the installation number, (As mentioned, "1" in most cases), and hit enter. The time now is 06:48 AM. -- Mobile_Default -- TSF - v2.0 -- TSF - v1.0 Contact Us - Tech Support Forum - Site Map - Community Rules - Terms of Did you notice if the popping sound was coming from the power adapter or from the laptop itself?

I replaced the hard drive.

MJ July 19, 2007 | yes, definately do not attempt to open up the notebook yourself if you still need to claim warranty because the warranty is voided once u open Then either buy a new drive (as this one may be bad) or put it back in and Boot off of the XP CD, Format and reinstall. 08-05-2009, 04:00 AM Just in case test the laptop with another AC adapter. 4. The Hard Drive indicator gives one blink.

You start the laptop and it starts making repetitive clicking noise or grinding noise. Lloyd June 13, 2007 | I have a Toshiba Tecra A5 here that won't continue past POST. Reassembled and Now removed all HDD, Cd drive, Battery, RAM's, PCMCIA card and tried to power up still no joy. Visit Website Now for the most important step of our process, the BOOTCFG /REBUILD command which searches for pre-existing installations of Windows XP and rebuilds sundry essential components of the Windows operating system,

Let me know if you get any good help from anywhere. The optical drive will not open. Login now. Can you see anything?

 
 
 

© Copyright 2017 hosting3.net. All rights reserved.